The objective this week was to rebuild the front suspension components back onto the sub-frame. When ADO16s were built in Abingdon, this was the way they were originally assembled.
After months of anticipation, the first parts to be installed were the driver’s (left hand) side upper control arm and hydraulic cup.
Making sure to properly lubricate each piece and “Anti-seizing” the threads will help prevent the problems that plagued these parts before.
The lower support arm and the hub came next. I made sure to tighten but not torque these in place since everything will have to be adjusted and aligned later.
And just for kicks, the bump stops were installed in the wheel wells.
I also took the radiator to the radiator shop to have it cleaned and checked out. My guess (since everything else on this car has needed a total overhaul) is that it will probably need a new core.
The radiator cap needs to be cleaned and repainted, too (but this is minor).
Assembling is fun!! Not bad for only three hours work.
Thanks for visiting.
Toddy
No comments:
Post a Comment